ij.start.canon ts3122


IJ.Start.Canon TS3122 – Canon Pixma TS3122 Setup Individuals ought to carry out the configuration process for accessing all incorporate from the Canon Pixma TS3122 Configuration. The treatment method on methods to create the printer is made available on this net webpage. The simple instructions consist of unpacking the printer, establishing the energy website link, inserting A4 paperwork, downloading and set up the chauffeur, and establishing the network website link

WPS Connection

  • Make absolutely sure the WPS button on the wireless router is prepared to be pressed.

  • Press and hold the Network button (A) on the printer, and then release the button when Network standing icon (B) flashes.

  • figure: Press and hold the Network button and the Network standing icon flashes
    Press and hold the WPS button on the wireless router inside of two minutes.

  • For a lot more on pressing the WPS button, see the wireless router guide.

  • When the connection to the wireless router is comprehensive, the Network standing icon and Signal Strength icon (C) will be lit.

  • The Network standing icon and Signal Strength icon are lit
    Troubleshooting

  • If the Alarm lamp lights up, see “Troubleshooting.”

Canon Pixma TS3122 Setup: WPS Connection Method

Before you proceed with the setup process, there are certain conditions that you need to fulfill for using the WPS button.

  • There must be a physical WPS button available on the access points.

  • Before you proceed, do not forget to check the user guide of the device to get all the details.

  • In case the WPS push button is not available, you can follow the standard connection method to complete the ij.start.canon TS3122 on your device.

Your network must support WPA or WPA2 security protocol. Most of the WPS-enabled access points prefer to use the protocol.

Here are the step by step instructions to follow for Canon Pixma TS3122 Wireless Setup:

Step 1

  • Turn On your Canon Pixma printer.

  • Now, press and hold the ‘WiFi’ button present at the top of your Canon Printer until you see the Alarm light start to flash.

Step 2

  • The light present next to the ‘WiFi’ button must start to flash ‘Blue’. After that, go to the ‘Access Point, and hit the ‘WPS’ button in just two minutes.

  • To know about the details to start WPS on your access point, you can refer to the instruction manual.

  • The WiFi Light ‘Blue’ on your Canon printer will continue to flash when searching. The ‘WiFi’ and ‘Power’ will blink when trying to connect to the access point.

  • Once the printer managed to establish a successful connection to the Wi-Fi network, the ‘Power’ and ‘WiFi’ light will stop flashing.

Confirm the Network Settings

To make sure whether the ij.start.canon TS3122 Wireless Setup is successfully completed or not, you can simply take a printout of your network settings. Here are the steps you need to follow for this:

  • Check and Make sure that your printer is turned on.

  • After that, insert the A4 size sheet or Letter-Sized plain paper.

  • Press and hold the ‘Cancel/Resume’ button until you see the Alarm light flashes 15 times. After that, you can release it.

The Network Information page will get printed

When you refer to the printout, check and make sure that the connection indicates ‘Active’, and SSID is showing the right name of your Wireless Network. The WPS Setup process is complete. Proceed with the installation of the driver in software for maximizing the outcomes. If you do not have the installation CD, you can simply visit the Canon official website and download the required driver and software for ij.start.canon TS3122 Wireless Setup.